Hi all...
After i attached the front and rear arms, i note that even the instructions said that it is extremely important that the arms move freely on pivot pins. They didn't at first, but after i pushed the holders out while i tightened em up, they seemed to do, except very very slightly they didn't move absolutely freely under their own weight. I don't have an arm reamer so i pushed on with the build, and figured i'd buy an arm reamer one day soon and re-try to get the arms to move freely under their own weight.
So, i got to now attaching the anti-roll bars., and note again that the instructions said to verify that both sides move at the same time. Well, mine dont. I've tried to tighten the screws only enough to remove excessive free play and still allow the anti-roll bar to move freely.
Does this all tie back to the arm's not moving freely? Should i go back to that step and ream the arms until they fall freely, and then continue the build?
Or is there some other things i can check with the anti-roll bars and the fact that both sides dont move at the same time?
Any help appreciated, thanks...
|