XRAY - Model racing cars

Hello,

I have a Problem with my NT1 2012 Spec.
Each wheel has play. I have axial play, The whole shaft with the wheel moves back and forth.
The trackwidth can not be set correctly. Do I fit between the inner bearing and the drive shaft washers?
The wheel hubs are fitted correctly, the shaft can be moved anyway.

Thx for Help !

I removed the play with washers 0,1mm. The axial play back en forward was very little with my car. The original parts have little play when new. I fitted them on the inside. But make sure you still have a very little play with the washers. Make sure the bearings don`t have too much play. They should fit thight in the hubs. The cvd should fit thight also in the bearings.
Thight = slides in with a little resistance.

Hope this helps you allthough its a little late to reply. i`m not that often on line.

A little bit of play (0.5-1mm) is nothing to worry about. You will not notice a big difference on the track. A nitro powered car like the NT1 already has so much vibration from the engine. Many other things have a bigger influence on handling.