XRAY - Model racing cars

Hi
Maybee I'm to accurate about this...
But all my T3'11,'12 and now the T4 all has come with
a slightly bent chassisplate.
I've taken the plate on several different flat surfaces and it's the same on all.
When I push down at the back end, it's lifting in front.
Is it supposed to be like this?

Thanks for answer
Fred

Since I started driving XRAY cars, 8 years ago, I have only seen one chassis to be slightly warped from the factory. The reason for this, I don't really know. If you have this problem, you should contact either your distributor, or XRAY directly, I am sure that they will replace it for you: info@teamxray.com

chassis deforms when you begin to fasten the screws. This happens on all models XRAY in recent years. And I do not mean to malfunction. This occurs because the screw heads spreads the carbon and chassis is begins to deform.

I had the same issue with my current T4 build. After sanding the excess ca glue of along the edges with a 400 grain sandpaper, the slight tweak was gone.