XRAY - Model racing cars

I have now got a very good setup for my car at my local track, which is fast and easy to drive.

However, when the track temp starts to come up alot on a hot day, 40degC or above, I start to occasioanly get oversteer on some corners.
It isn't really bad and the other drivers are having the same difficulty, but it would be nice to gain a small advantage over them once the track gets hot.

My individual lap times only varied by 0.1s from the track being 25degC right up to 50degC, but I need the consitency to help keep me near the front.

IF YOU CAN use harder compound
give 0,5 or 1mm shim on the outer rear hub
0,5mm or even 1mm more on the rear upper clamps

0,5mm less on front clamps

FRONT
outer the front(2mm on down and 4mm on up) and rear(2mm down and up) shocks

and give 1mm more on ackermann

should be more stable,probobly even faster

if it wont work give front and rear shocks 1 pos upright

If you send us your set up would be helpful

What I've run for the last few meetings;

okey then:
1.3mm anti roll bar in rear
ride height f5mm r5mm
downstop f6/r5
rear: shortest link 1mm on the clamps and 5mm on the rear hub
front: 2mm on c-hub
2mm on the ackermann
2.8 in front(or try even 3.0)
2.6 in rear
-1.5 camber in front and rear

SOLID lower suspension block


if it wont give what you would like to have try to give 10g on the front of the car and try mazda speed 6 body

Hope it'll help you

I don't want to get rid of any steering.