XRAY - Model racing cars

Hello again.

When the track is low grip. How can you get more traction? Using the Traction Control on your radio? I use Sanwa Exzes X, that is like Sanwa M11.

Thank you.

Don't bother with traction control or any of that rubbish, that's for nitro.

Just give yourself a soft setup and learn to be carefull with your throttle control.
If you can, lower the profile on your ESC so it isn't so aggressive.
The only radio setting I run normally is -15 to -20% on the steering expo to help smooth the steering a little.

The profile in your ESC. you reffer to the configuration program on speed control?

Thank you Skiddins and Hagberg.

I use the LRP SSX Stock 2.

The speed control has the programm 2 that is the punch. But I don't see so much appreciate when I change the value...

I was trainning yesterday and I did a combination on my sanwa radio of EXP (exponencial) throttle -30%, and ARC (adjust rate control) +30%. I race with 10.5 motor, on carpet.
Mi car had more forward traction and I get best time about 0.1sec per lap.

What I can't get is block wheel at braking. I would like to just brake without locking the wheels. I use the ALB (anti lock brake) with strocke 100%, point 90%, lag 0.0, speed -1%. Any idea about this? Change de EPA brake configuration?

Thank you.

Regards.

Sorry Skiddins for the moment I have not on Internet.

I just finded Skiddins.
This is the club. Carpet track. But wen change the circuit every 2 races. The next race will be sense clockwise and next the opposite. The driver is a friend.

http://www.youtube.com/watch?v=X8-0EIH96us

And this our asphat track (ETS):

http://www.youtube.com/watch?v=ceG5Z3MN ... =endscreen

Regards.

I don't know what you say "drag brake". The vídeo is with 13.5 motor. Actually we race with 10.5 motor.
I have thinked try tu reduce EPA brake, and then the SPEED brake...
I have already tested, but perhaps not enough.

Thank you Skiddins.

Drag brake is sometimes called Autobrake, it is an amount of brake that is applied by the ESC when the stick is in neutral.

Skiddins

AAAA okok, yes auto brake

For low traction use the low rear roll center suspension arm holders, little more rear toe in, 3-3.5 degrees, lean rear shocks in to second bottom hole, stand up front shocks, kit shock oil is fine (350cst), try harder front, softer rear if you are still breaking loose in the rear.
Raise front roll center a little if you have too much steering. Set throttle curve a little soft. I run on low traction asphalt in this works a treat

OK, thank you very much Kigna