little problem with rear toe in...

roger999 · **Posted:** Mon May 07, 2012 12:33:54

guy, any ideas what to do to have same toe in on rear left and right wheels? right hand side is 3 but left hand side is about 2.8..? i pushed the alu holders against tightening direction but still is not right.. First was 2.5 but now i could do it until 2.8 but still have no 3...

Stanley Bąk · **Posted:** Mon May 07, 2012 18:11:43

possibilities:
difrent hubs
difrent shims(compering on rear rear blocks)
tweaked main plate

check it

roger999 · **Posted:** Mon May 07, 2012 18:46:48

Stanley Bąk · **Posted:** Mon May 07, 2012 19:53:51

so then you have got sth wrong with your set up
you've got Hudy's set up station?

roger999 · **Posted:** Tue May 08, 2012 13:32:52

Peter Phillips · **Joined:** Wed Jan 25, 2012 18:08:50 **Posts:** 12

Best solution ive found is the solid suspension block, as ran by Alex at ETS Poland.

roger999 · **Posted:** Tue May 08, 2012 15:52:23

CharlesF · **Joined:** Fri Jul 15, 2011 10:18:37 **Posts:** 35

I've found this on every XRay I've had too, but not the T3'12 that I have now - the LHS rear toe is slightly less than RHS (I checked it with a straight-edge too, as I suspected my setup station for a while)

I just shimmed it to even it out (a 0.3mm shim usually works fine)

roger999 · **Posted:** Tue May 08, 2012 19:48:07

XRAY - Model racing cars

little problem with rear toe in...

Who is online