HELP With T3 New Diff

kenkeys · **Joined:** Tue Oct 11, 2011 05:33:41 **Posts:** 2

I've just installed the New Diff on the rear of my T3 I'm using the 52mm drive shafts, the rear A arms do not drop down freely like they did before I checked roll pins, If I disconnect one side the other side drops freely. if they are connected at the same time they do not drop freely. anybody know why that is ? any sugguestions ?

rduijkeren · **Posted:** Tue Oct 11, 2011 08:04:42

Martin Hudy · **Posted:** Tue Oct 11, 2011 09:10:29

Hi,

Maybe rear track width is too narrow, Make sure to have 3 degree toe in and 1.5 degree camber.

kenkeys · **Joined:** Tue Oct 11, 2011 05:33:41 **Posts:** 2

Hey thanks for the tip it did the job !

Martin Hudy · **Posted:** Wed Oct 12, 2011 08:10:06

Great to hear

In case you would like to use less toe in than 3 degree or use 1 degree rear hub, do not remove the 1.5mm shim but rather put shim into the front roll center holder on the rear arm.

XRAY - Model racing cars

HELP With T3 New Diff

Who is online