XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
808 pinion questions https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=9549 |
Page 1 of 1 |
Author: | tony montana [ Thu Aug 06, 2009 02:34:16 ] |
Post subject: | 808 pinion questions |
I just got a used 808. Where the bearings go on the pinion there was a big aluminum looking spacer that was between the 2 bearings. In the insrutions and supplemnt sheet there is no info of this piece. Wondering if Im suppose to use it or not? |
Author: | mrayner [ Thu Aug 06, 2009 03:15:33 ] |
Post subject: | |
This is a new part on the 09 spec buggies.... most people with the older 808 have upgraded to this to improve bearing wear. Defiantly use it ![]() |
Author: | Adrian E [ Thu Aug 06, 2009 22:27:36 ] |
Post subject: | |
Yep, as above The part number is 352075 - if you have a look at the supplementary instructions for the 09 spec it tells you not to undo the screws retaining the bearing, but to leave them done up, which is a change to what your manual is likely to say. They're not massive threads, so don't go mad on them - but they should be snug. Adrian |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |