XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Carbon disk brakes binding after warming up https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=9150 |
Page 1 of 1 |
Author: | vti-chris [ Sun May 03, 2009 15:47:37 ] |
Post subject: | Carbon disk brakes binding after warming up |
I've been using the carbon brake disks on the 808 for a while now on an open track which doesn't require much braking with no problems at all.I set the gap as stated on the manual. On our new track which is a tight track and requires a lot of braking it seems that after 2-3 fuel tanks the disks get tooo hot and "swell"(i'm not sure) but they do bind and the gap seems a lot smaller than the one i started with. Is there a solution: -bigger gap(the reason i used these disks was to minimize the linkage travel to minimum) -some use ofna springs(will this work) -go back to ferodo pads(rather not) |
Author: | patientbob [ Sun May 03, 2009 17:10:22 ] |
Post subject: | |
i use the answer spring , and have just raced with the new carbon pads today! had no problems there awesome ! put some springs in .. |
Author: | vti-chris [ Mon May 04, 2009 08:43:36 ] |
Post subject: | |
Author: | Tricksy [ Mon May 04, 2009 11:25:52 ] |
Post subject: | |
Author: | patientbob [ Mon May 04, 2009 11:30:06 ] |
Post subject: | |
Author: | patientbob [ Mon May 04, 2009 23:21:16 ] |
Post subject: | |
as promised , pics of carbon brakes & springs. and... hope this helps |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |