XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
What Glue for the Carbon Fibre sealing https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=9102 |
Page 1 of 1 |
Author: | NickB [ Wed Apr 22, 2009 00:37:59 ] |
Post subject: | What Glue for the Carbon Fibre sealing |
Hey folks! Just wondering what glue youd reccomend for sealing the carbon shock towers etc!? e.g. specific make you found to be better e.g. doesnt crack off! Thanks in advance, Nick |
Author: | omarwashington [ Wed Apr 22, 2009 01:19:53 ] |
Post subject: | |
use Thin ca glue I use Pacer Zap ca glue good stuff, I put about 2 or three coats on the carbon fiber |
Author: | Butcher [ Wed Apr 22, 2009 03:15:40 ] |
Post subject: | |
Pretty much any thin or med glue ment for our tires will work well.Make sure you sand the edges first just a bit fine paper works the most effficent like 400 grit or so.Few drops at top corner & let it run down to bottom corner then rotate part for next run.If your having it chip off,you've put it on too thick.Your goal is not to make a bumper around it just a light coat to keep the microscopic fibers from fraying & absorbing fluids thats all. |
Author: | NickB [ Wed Apr 22, 2009 11:01:47 ] |
Post subject: | |
Author: | Oli [ Wed Apr 22, 2009 11:29:06 ] |
Post subject: | |
Author: | NickB [ Wed Apr 22, 2009 19:14:46 ] |
Post subject: | |
Author: | Butcher [ Thu Apr 23, 2009 05:23:58 ] |
Post subject: | |
Author: | HulkRay [ Thu Apr 23, 2009 05:53:02 ] |
Post subject: | |
Author: | anf0 [ Thu Apr 23, 2009 08:48:06 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |