XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
09 808 downstop setting https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=9090 |
Page 1 of 1 |
Author: | Jlong [ Sat Apr 18, 2009 03:25:01 ] |
Post subject: | 09 808 downstop setting |
So, I'm working my way through the build of my 09 spec 808, and the manual says to set the downstop screw on the suspension arms at 2mm out on both ends. When I do this, the back end looks reasonable, but the front must be a misprint or something. With 2mm, the front arms are about level, I cant imagine that's what the starting setup is on the front. Anybody run across this? I think this part of the manual is the same as last years 808. |
Author: | Bren Ralls [ Sat Apr 18, 2009 08:03:07 ] |
Post subject: | |
The settings are only a guide. THe most accurate way to measure it is with the Hudy set up station. The simplest way is to attach the shocks & measure centre of the two mount screws. Now adjust the downstops screw to achieve length of Front 104mm & Rear 114mm, this will be a good start point. Bren |
Author: | vti-chris [ Sat Apr 18, 2009 14:43:26 ] |
Post subject: | |
Author: | Jlong [ Sat Apr 18, 2009 18:36:21 ] |
Post subject: | |
Author: | Tricksy [ Sat Apr 18, 2009 20:24:15 ] |
Post subject: | |
Author: | Tricksy [ Sat Apr 18, 2009 20:26:46 ] |
Post subject: | |
Author: | Bren Ralls [ Sat Apr 18, 2009 20:32:38 ] |
Post subject: | |
Author: | Jlong [ Sun Apr 19, 2009 01:44:20 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |