| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Low Weight XB 808 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=8543 |
Page 1 of 2 |
| Author: | alphaaut [ Mon Dec 08, 2008 21:06:40 ] |
| Post subject: | Low Weight XB 808 |
| Author: | Rocco Margiotta [ Mon Dec 08, 2008 21:26:15 ] |
| Post subject: | |
| Author: | alphaaut [ Mon Dec 08, 2008 21:36:25 ] |
| Post subject: | |
| Author: | Rocco Margiotta [ Mon Dec 08, 2008 23:14:05 ] |
| Post subject: | |
Everything listed above are the only items that are lighter than the stock pieces (other than the aluminum hinge pin holders that are just a hair heavier than stock). Titanium shouldn't be that much lighter, that amount would be around the weight of aluminum, make sure your source's information is correct. To respond to your PM, I am running this lipo: Dualsky 1500 RX lipo (ignore the regulator, its the only pic I could find online where the link worked) |
|
| Author: | nvanderpool [ Tue Dec 09, 2008 02:03:32 ] |
| Post subject: | Aluminum Axles |
Hey Rocco after Sundays A-main aluminum axle snap are you sure you want to keep running them! Of course you would need to save some considerable weight if you keep driving with a glow igniter on your car!!!!LOLOLOLOL!! Good pit men are hard ti find! |
|
| Author: | Rocco Margiotta [ Tue Dec 09, 2008 17:40:27 ] |
| Post subject: | Re: Aluminum Axles |
| Author: | alphaaut [ Tue Dec 09, 2008 18:22:50 ] |
| Post subject: | |
| Author: | Rocco Margiotta [ Tue Dec 09, 2008 22:12:57 ] |
| Post subject: | |
| Author: | alphaaut [ Tue Dec 09, 2008 22:16:59 ] |
| Post subject: | |
| Author: | Rocco Margiotta [ Tue Dec 09, 2008 22:25:31 ] |
| Post subject: | |
| Author: | lauri [ Wed Dec 10, 2008 01:19:07 ] |
| Post subject: | |
| Author: | XT8Truggy [ Wed Dec 10, 2008 10:19:09 ] |
| Post subject: | |
| Author: | Rocco Margiotta [ Wed Dec 10, 2008 17:22:48 ] |
| Post subject: | |
| Author: | Robin Frischkopf [ Wed Dec 10, 2008 17:48:32 ] |
| Post subject: | |
| Author: | Rocco Margiotta [ Wed Dec 10, 2008 18:08:57 ] |
| Post subject: | |
| Author: | motorboyduc [ Wed Dec 10, 2008 18:47:47 ] |
| Post subject: | |
| Author: | XT8Truggy [ Wed Dec 10, 2008 23:03:16 ] |
| Post subject: | |
| Author: | GregM [ Thu Dec 11, 2008 10:13:26 ] |
| Post subject: | |
I've been running a KO 2413 Low Profile servo for Throttle/Brake with no issues so far, been in the car since new, so just about 9 months. |
|
| Author: | illebille [ Mon Dec 15, 2008 23:21:41 ] |
| Post subject: | |
| Author: | Rocco Margiotta [ Mon Dec 15, 2008 23:47:26 ] |
| Post subject: | |
| Page 1 of 2 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|