XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
servo saver how tight is yours https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=8484 |
Page 1 of 1 |
Author: | Ronaldo808 [ Fri Nov 21, 2008 23:16:41 ] |
Post subject: | servo saver how tight is yours |
Author: | Flygio [ Sat Nov 22, 2008 14:10:26 ] |
Post subject: | |
Author: | Ronaldo808 [ Sat Nov 22, 2008 14:15:37 ] |
Post subject: | |
Author: | MALLET [ Sat Nov 22, 2008 14:24:05 ] |
Post subject: | |
It will break the joint in the steering servo saver if you clash with something instead of taking your servo gear out. It basically means that you can still keep racing after you have hit something. |
Author: | Ronaldo808 [ Sat Nov 22, 2008 15:58:28 ] |
Post subject: | |
Author: | MALLET [ Sat Nov 22, 2008 16:08:48 ] |
Post subject: | |
Author: | Steve Walters [ Sat Nov 22, 2008 17:34:48 ] |
Post subject: | |
Author: | MALLET [ Sat Nov 22, 2008 18:29:32 ] |
Post subject: | |
Author: | Ronaldo808 [ Sat Nov 22, 2008 20:49:13 ] |
Post subject: | |
Author: | MALLET [ Sat Nov 22, 2008 21:16:27 ] |
Post subject: | |
Author: | Ronaldo808 [ Sun Nov 23, 2008 00:15:06 ] |
Post subject: | |
Author: | Bazza [ Sun Nov 23, 2008 20:44:22 ] |
Post subject: | |
Author: | Tricksy [ Thu Nov 27, 2008 20:46:31 ] |
Post subject: | |
Author: | MALLET [ Thu Nov 27, 2008 23:37:06 ] |
Post subject: | |
Author: | Tricksy [ Thu Nov 27, 2008 23:46:02 ] |
Post subject: | |
Author: | Oli [ Fri Nov 28, 2008 15:42:31 ] |
Post subject: | |
What I have found is tightening it up too tight can lead to the servo horn stripping (if you run the xray horn). I'd prefer to have a little less turn in than have a horn strip and not finish a race! But I think I'm also gonna tighten mine up a little, especially as I've now got an AD to try out! |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |