XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
XT8 Throttle Servo Arm Issue https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=8075 |
Page 1 of 1 |
Author: | pottsgroverc [ Tue Jul 29, 2008 16:06:20 ] |
Post subject: | XT8 Throttle Servo Arm Issue |
My throttle servo arm keeps sticking. After I give it gas the car remains at a higher idle, but when I hit the brakes the throttle goes back to where I have it tuned. You can actually see it "pop" the rest of the way in. It is only sticking about 1 to 0.5 mm out. It is not the carb, already tested it out of the car. Already tested the servo as well and it is working fine. I believe it is somewhere between the arm and the brake caliper. Was wondering if anyone experienced a similar problem. Thanks. |
Author: | Rocco Margiotta [ Tue Jul 29, 2008 16:18:09 ] |
Post subject: | |
Could you post some pics of your linkage. Check the angle between the throttle linkage to your and where it mounts on the carb, make sure it's straight, as an angle could make the carb slide bind. |
Author: | pottsgroverc [ Fri Aug 01, 2008 03:31:17 ] |
Post subject: | |
I will try to get a close up photo ASAP, just my camera isn't too good at close range, but I'll try. Thanks Rocco. |
Author: | Keith [ Sat Aug 02, 2008 17:40:47 ] |
Post subject: | |
Author: | MARK TARRIER [ Mon Aug 04, 2008 21:40:13 ] |
Post subject: | |
is this a common prob as i had running on probs when i run my car yesterday 4 the first time, not run this engine so want to be shore its linkage probs and not engine? Any other advice/tips with setup would be helpfull as racing on the weekend and would like to iron out any troubles b4? pm 4 tips cheers Mark ![]() i hope my BOB is quicker than my RC8 ![]() ![]() |
Author: | MALLET [ Mon Aug 04, 2008 23:52:46 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |