I knew you had to be on a vacation / break! Thanks for the tip, will try it asap.
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| "Jumping" question https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=7984 |
Page 1 of 1 |
| Author: | Richmond [ Sat Jul 12, 2008 05:59:54 ] |
| Post subject: | "Jumping" question |
| Author: | Richmond [ Sun Jul 13, 2008 06:12:10 ] |
| Post subject: | |
| Author: | Kahuna77 [ Sun Jul 13, 2008 06:15:54 ] |
| Post subject: | |
| Author: | jono_EC [ Sun Jul 13, 2008 06:20:27 ] |
| Post subject: | |
| Author: | leebunker [ Sun Jul 13, 2008 23:20:26 ] |
| Post subject: | |
| Author: | UndergroundRC [ Mon Jul 14, 2008 06:21:39 ] |
| Post subject: | |
- Less droop in the rear (arms more flat), will stop the rear-end from raising too high. Too much rear droop (hanging to far down) can cause endo issues off jumps. - To get similar front end effect on "air balance", you could also allow a bit more front droop. All this,.. assuming you have the proper ride height for the track conditions... of course. Bottoming out off jump faces can cause many crazy things to happen, including the dreaded endoooo. Just pay more attention to the track conditions and double check your ride height very often. |
|
| Author: | jonw [ Mon Jul 14, 2008 12:24:38 ] |
| Post subject: | |
| Author: | Oli [ Mon Jul 14, 2008 15:28:24 ] |
| Post subject: | |
| Author: | Rocco Margiotta [ Mon Jul 14, 2008 17:06:47 ] |
| Post subject: | |
| Author: | Richmond [ Tue Jul 15, 2008 05:00:15 ] |
| Post subject: | |
I knew you had to be on a vacation / break! Thanks for the tip, will try it asap.
|
|
| Author: | Andy Taylor [ Tue Jul 15, 2008 15:36:22 ] |
| Post subject: | Re: "Jumping" question |
| Author: | NeilMcRae [ Wed Jul 16, 2008 22:08:53 ] |
| Post subject: | |
| Author: | Richmond [ Thu Jul 17, 2008 00:09:15 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|