XRAY - Model racing cars

Yes, you can get the XB8 EC aluminum hinge pin holders to replace the captured hinge pin system that comes on the XT8.

Send a PM to Brano or Rocco or they will see this and post all the correct part #'s that you will need to get the job done.

Check this link where you can find all info viewtopic.php?p=59103

The XB808 holders will not fit your XT8.

I'm sure this info is in Brano's link, but check out part #352300. It should have everything you need to take off the e-clips.

Another cheap way to get rid of the e-clips is to use the MBX5T Hinge pins...its a direct fit

352301- Euros front
352320- Front lower holder rear

353312- rear lower holder rear
353312- rear lower holder front
352315- eccentric bushings for holders
357212- Lower inner hinge pins

351200- XB8 frt & rr bumper, you'll nead the rear bumper to fill the void when adding this upgrade.


This is exactly what I ordered for my XT8, in short it's the Euros front and rear but ordering rear components seperately to do without the rear shock tower.