XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
XT8 Captured Hinge Pins https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=7841 |
Page 1 of 1 |
Author: | pottsgroverc [ Fri Jun 13, 2008 05:40:38 ] |
Post subject: | XT8 Captured Hinge Pins |
Author: | Jason Branham [ Fri Jun 13, 2008 13:13:47 ] |
Post subject: | |
Yes, you can get the XB8 EC aluminum hinge pin holders to replace the captured hinge pin system that comes on the XT8. Send a PM to Brano or Rocco or they will see this and post all the correct part #'s that you will need to get the job done. |
Author: | brano [ Fri Jun 13, 2008 13:49:47 ] |
Post subject: | |
Check this link where you can find all info viewtopic.php?p=59103 The XB808 holders will not fit your XT8. |
Author: | Rocco Margiotta [ Fri Jun 13, 2008 16:46:17 ] |
Post subject: | |
I'm sure this info is in Brano's link, but check out part #352300. It should have everything you need to take off the e-clips. |
Author: | Barracuda [ Fri Jun 13, 2008 17:14:13 ] |
Post subject: | |
Another cheap way to get rid of the e-clips is to use the MBX5T Hinge pins...its a direct fit |
Author: | ldp787 [ Fri Jun 13, 2008 18:42:38 ] |
Post subject: | |
352301- Euros front 352320- Front lower holder rear 353312- rear lower holder rear 353312- rear lower holder front 352315- eccentric bushings for holders 357212- Lower inner hinge pins 351200- XB8 frt & rr bumper, you'll nead the rear bumper to fill the void when adding this upgrade. This is exactly what I ordered for my XT8, in short it's the Euros front and rear but ordering rear components seperately to do without the rear shock tower. |
Author: | pottsgroverc [ Sat Jun 14, 2008 04:29:31 ] |
Post subject: | |
Author: | Stanley Wangsanegara [ Sun Jun 15, 2008 08:04:48 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |