XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Upper A-arm mod https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=7613 |
Page 1 of 1 |
Author: | Richmond [ Sat May 03, 2008 16:04:29 ] |
Post subject: | Upper A-arm mod |
Author: | Tank time [ Sat May 03, 2008 23:58:16 ] |
Post subject: | |
On the XT8 and EC there will no support if you cut the bridge out. If you did cut the bridge out the length to the outside joint is too long and it causes a larger rotation in a crash. Therefore, too much torque will be applied to it and it will break for sure. However, it would work on the upper arms provided with the 3D ackerman plate. Just ream the upper arm out with a drill and it also gives you more roll center adjustments with out causing binding. Hmmm, you could fit the front upper arms off the 808..... |
Author: | guy02 [ Sun May 04, 2008 17:16:43 ] |
Post subject: | |
Author: | Rocco Margiotta [ Sun May 04, 2008 17:19:36 ] |
Post subject: | |
Author: | guy02 [ Sun May 04, 2008 19:46:05 ] |
Post subject: | |
Author: | daz.fx [ Sun May 04, 2008 20:02:24 ] |
Post subject: | |
How is it mounted to the shocktower cos there is an oval shape hole ? |
Author: | guy02 [ Sun May 04, 2008 20:25:00 ] |
Post subject: | |
new holes drilled between oval holes and edges of tower |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |