XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Need help please engine screws https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=7407 |
Page 1 of 1 |
Author: | HulkRay [ Thu Apr 03, 2008 03:30:03 ] |
Post subject: | Need help please engine screws |
Here are pic's of the screw that I strip a bit that I can not use the correctly 2.0mm tool.. Whats the best action I can take to get this screw out... Thanks Felix |
Author: | daryl denny [ Thu Apr 03, 2008 03:34:34 ] |
Post subject: | |
Use a cut off wheel in your dremel to cut a slot in the head of the screw. Then remove the screw with a flat head screwdriver. |
Author: | Rocco Margiotta [ Thu Apr 03, 2008 04:26:42 ] |
Post subject: | |
What he said. The heat generated by cutting screw will release any thread locker and make the screw very easy to remove. Always use a cap-head screw and this won't happen again! |
Author: | HulkRay [ Thu Apr 03, 2008 05:14:28 ] |
Post subject: | |
Author: | BRIAN77 [ Thu Apr 03, 2008 11:09:56 ] |
Post subject: | |
see if u could grip visescripes onto the screw and try it that way too. |
Author: | Andy Taylor [ Fri Apr 04, 2008 00:54:00 ] |
Post subject: | Re: Need help please engine screws |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |