XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Hudy Engine Break In Stand https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=7391 |
Page 1 of 1 |
Author: | Qball [ Mon Mar 31, 2008 04:23:27 ] |
Post subject: | Hudy Engine Break In Stand |
Author: | robknasel [ Mon Mar 31, 2008 14:31:36 ] |
Post subject: | Cheaper option |
Author: | Qball [ Mon Mar 31, 2008 14:52:41 ] |
Post subject: | |
Author: | Rocco Margiotta [ Mon Mar 31, 2008 14:56:00 ] |
Post subject: | |
Author: | Qball [ Mon Mar 31, 2008 16:41:24 ] |
Post subject: | |
Author: | Barkley Abernethy [ Mon Mar 31, 2008 18:57:48 ] |
Post subject: | |
Author: | Rocco Margiotta [ Mon Mar 31, 2008 22:33:09 ] |
Post subject: | |
Author: | rcjunky10 [ Mon Mar 31, 2008 22:45:50 ] |
Post subject: | |
Author: | Barkley Abernethy [ Mon Mar 31, 2008 22:58:37 ] |
Post subject: | |
Author: | dsavin [ Mon Mar 31, 2008 23:42:06 ] |
Post subject: | |
Author: | Barkley Abernethy [ Tue Apr 01, 2008 00:01:21 ] |
Post subject: | |
Author: | low10s [ Tue Apr 01, 2008 04:10:11 ] |
Post subject: | |
you will need more than a drill...an airplane starter is the way to go. i tried with a drill and it is too slow. |
Author: | TMizzle [ Tue Apr 01, 2008 04:59:45 ] |
Post subject: | |
it doesnt seem like there is enough resistance to go full throttle. Anything about 1/4 throttle the engine is SCREAMING and it just doesnt sound good. loud + it sounds like it leans out a little and will do damage if you hold it above 1/4-1/2 throttle. |
Author: | Tank time [ Tue Apr 01, 2008 14:40:41 ] |
Post subject: | |
Author: | Barkley Abernethy [ Tue Apr 01, 2008 18:55:36 ] |
Post subject: | |
Author: | Rocco Margiotta [ Tue Apr 01, 2008 19:11:56 ] |
Post subject: | |
Author: | low10s [ Wed Apr 02, 2008 02:09:57 ] |
Post subject: | |
Author: | kilana [ Wed Apr 02, 2008 03:32:41 ] |
Post subject: | |
I found this webpage by accident. They also used a 12V airplane electric starter. http://www.twf8.ws/new/tech/engine/brea ... bench.html |
Author: | dsavin [ Fri Apr 11, 2008 23:21:59 ] |
Post subject: | |
Author: | Keith [ Sun Apr 13, 2008 16:48:31 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |