XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
XT8 Basline Setup https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=7362 |
Page 1 of 1 |
Author: | jsob [ Wed Mar 26, 2008 13:29:31 ] |
Post subject: | XT8 Basline Setup |
Author: | Jason Branham [ Wed Mar 26, 2008 14:29:16 ] |
Post subject: | |
xform/index.php?act=view&ID=170&setup=xt8 jsob - try this set-up. If you need mor off power steering then go down on the caster setting. |
Author: | jsob [ Wed Mar 26, 2008 23:21:49 ] |
Post subject: | |
Author: | Jason Branham [ Wed Mar 26, 2008 23:45:31 ] |
Post subject: | |
Author: | boogeyman [ Thu Mar 27, 2008 01:08:35 ] |
Post subject: | |
1st you have to find a hudy setup station lmao ![]() |
Author: | jsob [ Thu Mar 27, 2008 01:27:58 ] |
Post subject: | XT8 Baseline setup |
Who has the Hudy Setup System for the best price? I have seen Item # 108805 and Item # 108841 at CarolinasRC.com 108805 is $129.99 and Item # 108841 is $30.99. These are the correct Items right? Do you need a certian antenna tube for a Nomadio receivers antenna? In your experience how good were the manuals measurements for all of the tie rods and turnbuckles? Sorry about the 50 questions this is my first 1/8th scale vehicle! |
Author: | Jason Branham [ Thu Mar 27, 2008 02:06:22 ] |
Post subject: | |
jsob, If you call RCAMERICA @ (214)744-2400 they should be able to answer all your set-board questions. I don't know much about the Nomadio Radios but I would think any antenna tube that fits should work. The manuals measurements should be a great starting point to go from. You can atleast do the old coke can next to the wheels to see if you have 0 camber. |
Author: | jsob [ Thu Mar 27, 2008 03:28:22 ] |
Post subject: | |
Thank You will do! |
Author: | gtsum [ Fri Mar 28, 2008 03:01:00 ] |
Post subject: | |
Author: | jsob [ Sat Mar 29, 2008 06:34:49 ] |
Post subject: | XT8 Baseline Setup |
Author: | gtsum [ Sat Mar 29, 2008 16:02:13 ] |
Post subject: | Re: XT8 Baseline Setup |
Author: | jsob [ Sun Mar 30, 2008 21:14:40 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |