Thank you for quick respond. I have already check out inserts ( two times) I will do it one more time to be sure. I have these special nuts from Hudy on my set up station, well i have strong hands so it is likely that I have tight it to much
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Problem with rear toe-in in my XT8 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=7209 |
Page 1 of 1 |
| Author: | Svanur [ Fri Feb 29, 2008 23:43:29 ] |
| Post subject: | Problem with rear toe-in in my XT8 |
| Author: | daz.fx [ Fri Feb 29, 2008 23:57:39 ] |
| Post subject: | |
First i have to suggest the obvious (sorry), check the inserts are the same. Make sure the screw is not too tight on the setup station. I've noticed you can get some drag giving false readings, only screw up very lightly. |
|
| Author: | Svanur [ Sat Mar 01, 2008 00:27:30 ] |
| Post subject: | |
Thank you for quick respond. I have already check out inserts ( two times) I will do it one more time to be sure. I have these special nuts from Hudy on my set up station, well i have strong hands so it is likely that I have tight it to much
|
|
| Author: | Svanur [ Sat Mar 01, 2008 03:56:21 ] |
| Post subject: | |
Well you where right  it seems like I had fault insert in outer toe in adjustment. I took it out and placed it with 0 offset insert. And no it is equal on both wheels 2.5°.....Well it should have been 3° but i don't bother. I can always adjust it later with other inserts  Now I just need to figure out,
how I could make this mistake I worked as mechanic engineer for about 25 years and last 8 years as technical energy and engine engineer  Thanks for good instructions.
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|