XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Rear Uprights. A new problem found? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=704 |
Page 1 of 1 |
Author: | grahama89 [ Tue Dec 28, 2004 02:31:22 ] |
Post subject: | Rear Uprights. A new problem found? |
Has anyone else had this? |
Author: | Brandon Powell [ Tue Dec 28, 2004 02:39:56 ] |
Post subject: | |
Graham, Picture is not coming through on my computer. What is the picture of. |
Author: | imaxx21 [ Tue Dec 28, 2004 02:42:10 ] |
Post subject: | |
nice pic.....havnet seen that yet here |
Author: | Brandon Powell [ Tue Dec 28, 2004 03:02:21 ] |
Post subject: | |
First time for me. We have about 6 XB8's ruinning at our local track. |
Author: | grahama89 [ Tue Dec 28, 2004 03:33:34 ] |
Post subject: | |
Both of mine went like that. I was runing in the top hole and half way through the race it started pulling left. Then suddenly went straight again. THEN it pulled right. So I brought her in and this had happened. Luckily I TQed to the A on the laps I'd done. But I now have it like this. |
Author: | z-man [ Tue Dec 28, 2004 05:23:46 ] |
Post subject: | |
nice Hyper or is it a Xray????lol |
Author: | imaxx21 [ Tue Dec 28, 2004 05:58:02 ] |
Post subject: | |
looks like OFN |
Author: | jontejsson [ Tue Dec 28, 2004 08:54:01 ] |
Post subject: | |
I think It's a XB8 with OFNA rear uprights, direct fit ![]() |
Author: | mario [ Tue Dec 28, 2004 11:23:45 ] |
Post subject: | |
I do not understand as I can not see the first picture posted. |
Author: | Stanley Wangsanegara [ Tue Dec 28, 2004 11:45:29 ] |
Post subject: | MBX5 Pro Spec Hub |
If somebody in this forum have MBX5 Prospec, try to use Pro Spec rear hub in XB8. Put the rear upper link in the top outer hole in the hub and original position in the shock tower. The rear end would be easier to control out of corner, I would say much easier to control. But, when you install the hub, you need Prospec Upper Link and some 8x12mm rings (total 1 mm thickness to fill the gap because the distance between 2 bearings is closer in Pro Spec Rear Hub than in XB Rear Hub). Pro Spec Upper Link is used because if you use the original upper link it would scrub the inside part of the wheel. If somebody try this, please let me know. I really want to discuss. Thanks. |
Author: | grahama89 [ Tue Dec 28, 2004 12:17:55 ] |
Post subject: | |
Is that better Mario? |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |