I read somewhere that the pressure line shouldn't be less than 9 inch to smooth out the pulses. The fuel line was 15 inch but not sure why. I have a lengthy one ( thats right
) so it don't lean out or run out when i go upside down.
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Plumbing on my TQ... https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=6854 |
Page 1 of 1 |
| Author: | winkje [ Wed Jan 02, 2008 20:37:16 ] |
| Post subject: | Plumbing on my TQ... |
Hi, I changed the the fuel lines on my TQ. My air filter fits perfectly if I do it this way. I like the lines to be short but I'm really not sure if this is too short... Your feedback is appreciated ! Regards, vincent P.S. Don't get fooled by the 'tank opener'.... |
|
| Author: | daz.fx [ Wed Jan 02, 2008 20:52:22 ] |
| Post subject: | |
I read somewhere that the pressure line shouldn't be less than 9 inch to smooth out the pulses. The fuel line was 15 inch but not sure why. I have a lengthy one ( thats right ) so it don't lean out or run out when i go upside down.
|
|
| Author: | Luke [ Wed Jan 02, 2008 21:46:42 ] |
| Post subject: | |
i think that's right, maybe the pressure line its a little bit short, but the os is a 3 port, so maybe it's ok... For example, with my picco (7 port) i need a very long pressure line 
|
|
| Author: | MALLET [ Wed Jan 02, 2008 21:47:43 ] |
| Post subject: | |
Daz is right with the pressure line, keep it around the 9 inch to smooth the pulsing, but I've been told to go as little as 4 inch on the fule line side. You are bragging again Daz, my wife didn't say that when she saw it, she was laughing at you
|
|
| Author: | whitey4311 [ Thu Jan 03, 2008 04:19:05 ] |
| Post subject: | |
| Author: | low10s [ Fri Jan 04, 2008 05:58:53 ] |
| Post subject: | |
i dont run alot of long fuel lines, i like them short i guess, it is hard to tell the diff in my case, just easier to stay pressurized. even ran them short in gas truck. |
|
| Author: | WheelNut [ Sun Jan 06, 2008 08:59:36 ] |
| Post subject: | |
| Author: | lauri [ Sun Jan 06, 2008 14:10:38 ] |
| Post subject: | |
| Author: | whitey4311 [ Sun Jan 06, 2008 17:30:01 ] |
| Post subject: | |
| Author: | evan28 [ Mon Jan 07, 2008 10:24:54 ] |
| Post subject: | |
how do u go at a sanctioned event with so much fuel line when u can only legally hold 125cc in tank & fuel lines? or do you guys just club race. |
|
| Author: | lauri [ Mon Jan 07, 2008 13:43:30 ] |
| Post subject: | |
Sorry, I was talking about XT8... and you should always read rules before making changes. Running two fuel filters made the engine lean out quite much with empty fuel-tank. I ran with one fuel filter afterwards and had enough runtime. There are races with different rules and then some tinkering is now-and-then needed. |
|
| Author: | whitey4311 [ Mon Jan 07, 2008 16:43:59 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|