unfortunately there are no set measurements (that you are looking for) - at least that I know of (because I asked the same thing many months ago). Do like Whitey said and make sure the droop screws are limiting the droop, instead of the shocks bottoming out (or else you WILL have busted washers on the bottom of the pistons...trust me..been there and done that many times). I like equal droop front and rear and put the car on blocks and measure from under the hubs down the ground - I want them to be the same at all 4 corners....(I do this after getting the shocks set to where they are all limited from their max droop by about 2 mm) - I get that from measuring the shock length eye to eye...
|