When you do go at it with the dremel keep and eye on the actual drive shaft the uni joint as that will stop you from getting any more throw. as Bren said your wheel will start to rub on the turn buckles
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Steering Throw Modification (Increase) https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=6818 |
Page 1 of 1 |
| Author: | NCALENDA [ Tue Dec 25, 2007 20:57:04 ] |
| Post subject: | Steering Throw Modification (Increase) |
| Author: | whitey4311 [ Tue Dec 25, 2007 21:34:55 ] |
| Post subject: | |
| Author: | Qball [ Wed Dec 26, 2007 00:03:15 ] |
| Post subject: | |
Does anyone know where the pics can be found cause all I'm seeing is X's. |
|
| Author: | 20 SMOKE [ Wed Dec 26, 2007 01:16:22 ] |
| Post subject: | |
I was going to do the mod my self but after a few setup changes i don't even use full throw but it is close to full throw |
|
| Author: | DaleJrRocks8 [ Wed Dec 26, 2007 01:46:40 ] |
| Post subject: | |
viewtopic.php?t=64&start=0&postdays=0&postorder=asc&highlight= scroll half way down...you should see it. |
|
| Author: | NCALENDA [ Wed Dec 26, 2007 03:42:34 ] |
| Post subject: | |
| Author: | Craige Lewis [ Wed Dec 26, 2007 04:08:33 ] |
| Post subject: | |
| Author: | Qball [ Wed Dec 26, 2007 04:51:55 ] |
| Post subject: | |
| Author: | gtsum [ Wed Dec 26, 2007 05:47:35 ] |
| Post subject: | |
| Author: | Qball [ Wed Dec 26, 2007 06:20:35 ] |
| Post subject: | |
| Author: | gtsum [ Wed Dec 26, 2007 07:12:42 ] |
| Post subject: | |
| Author: | Bren Ralls [ Wed Dec 26, 2007 09:39:22 ] |
| Post subject: | |
Q ball the steering mod is very simple, alot of the steering you want can be achieved by just set up alone but will not do anything for a tight off power hair pin as all you need is more lock. For the XT8 you will need the ali knuckles & its just a case of dremeling away the back slightly where it touches the steering hub. You cant take off alot though as the wheel starts to rub on turnbuckle ball joint. Will try & post pictures later but am off to work now. By the sounds of it I have a similar driving style to qtsum & the advice is very good. this is my start point to most tracks xform/index.php?act=view&ID=222&setup=xt8 Most of the guys in the uk that have tried like the way the truck pivots in the corners. Bren |
|
| Author: | Craige Lewis [ Wed Dec 26, 2007 10:01:46 ] |
| Post subject: | |
When you do go at it with the dremel keep and eye on the actual drive shaft the uni joint as that will stop you from getting any more throw. as Bren said your wheel will start to rub on the turn buckles
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|