| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| 4200 reciever pack https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=6806 |
Page 1 of 1 |
| Author: | William [ Sun Dec 23, 2007 04:47:15 ] |
| Post subject: | 4200 reciever pack |
Hey guys I was wandering if any of yall have ever used one of these in the XB8 thinkin about getting one for long mains.I would like to hear some opinions. I know alot of yall have went to lipos but I dont want one possibly blowing up in my car because that is just my luck.  http://www3.towerhobbies.com/cgi-bin/wt ... XMTX4&P=ML
|
|
| Author: | tallyram [ Sun Dec 23, 2007 04:59:47 ] |
| Post subject: | |
i don't think it will fit in the battery box. |
|
| Author: | William [ Sun Dec 23, 2007 05:01:50 ] |
| Post subject: | |
I just measured it and sadly it wont fit. 
|
|
| Author: | whitey4311 [ Sun Dec 23, 2007 05:18:46 ] |
| Post subject: | |
Dang! that is a huge battery capacity for only a 6v NIMH. Just get the 2400mah lipo since it will give better performance. Lipos allow a constant 6v to the servos which will make them perform at max speed and torque at all times. Non Lipo packs will drop volts as they get run down making the servos performance decrease as the battery is used. |
|
| Author: | low10s [ Sun Dec 23, 2007 15:55:27 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|