XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
putting my XT8 together https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=6796 |
Page 1 of 1 |
Author: | NCALENDA [ Fri Dec 21, 2007 23:35:20 ] |
Post subject: | putting my XT8 together |
Author: | carlo71 [ Fri Dec 21, 2007 23:40:07 ] |
Post subject: | |
Author: | gtsum [ Sat Dec 22, 2007 00:28:39 ] |
Post subject: | |
Author: | Brian M [ Sat Dec 22, 2007 00:40:34 ] |
Post subject: | |
Author: | NCALENDA [ Sat Dec 22, 2007 00:49:12 ] |
Post subject: | |
Author: | NCALENDA [ Sat Dec 22, 2007 01:01:56 ] |
Post subject: | |
Here the docs: Page 11, Tech Tip FRONT & REAR DIFF GEAR MESH ADJUSTMENT In the event that the composite diff bulkhead allows too much diff side play, this may create non-optimal gear mesh between the diff spur gear and the pinion drive gear. This is easily resolved by inserting 1 or 2 of the included thin shims behind a diff outdrive ball-bearing, depending on how much play there is. --- Does this mean I don't have to do this? |
Author: | Andy Taylor [ Sat Dec 22, 2007 01:16:40 ] |
Post subject: | |
Author: | NCALENDA [ Sat Dec 22, 2007 01:25:40 ] |
Post subject: | |
Author: | J. DeLarge [ Sat Dec 22, 2007 01:45:01 ] |
Post subject: | |
I run the XB8EC and that has the same basic diff setup as the truggy, but anyways when I first put it together it was fine but after a little running it needed one. BTW most people hear music and it goes to their ears not their eyes. ![]() |
Author: | whitey4311 [ Sat Dec 22, 2007 03:49:01 ] |
Post subject: | |
Author: | daryl denny [ Sat Dec 22, 2007 16:22:26 ] |
Post subject: | |
Author: | low10s [ Sat Dec 22, 2007 19:36:23 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |