| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| the O-clip https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=6548 |
Page 1 of 1 |
| Author: | jayxb8 [ Wed Nov 07, 2007 04:46:59 ] |
| Post subject: | the O-clip |
| Author: | whitey4311 [ Wed Nov 07, 2007 04:53:45 ] |
| Post subject: | |
| Author: | kaan [ Wed Nov 07, 2007 08:22:21 ] |
| Post subject: | Re: the O-clip |
| Author: | MALLET [ Wed Nov 07, 2007 16:08:46 ] |
| Post subject: | |
I've changed mine to the Hong Nor Cir clips:- item number 315s 7mm C ring. Had no problems since doing this. Tim |
|
| Author: | whitey4311 [ Wed Nov 07, 2007 16:56:52 ] |
| Post subject: | |
| Author: | whitey4311 [ Wed Nov 07, 2007 17:15:00 ] |
| Post subject: | |
| Author: | MALLET [ Wed Nov 07, 2007 18:34:06 ] |
| Post subject: | |
It does keep them flatter and I've not had any problems of leaking since changing them over. You only need to use something similar to these http://cgi.ebay.com/CIRCLIP-PLIERS-4-PC ... dZViewItem Tim[/url] |
|
| Author: | whitey4311 [ Wed Nov 07, 2007 18:52:46 ] |
| Post subject: | |
dead link. Any online stores carry that C-ring? |
|
| Author: | MALLET [ Wed Nov 07, 2007 19:17:43 ] |
| Post subject: | |
Whitey try the link again it works now found some on US ebay |
|
| Author: | MDJammin [ Wed Nov 07, 2007 21:23:31 ] |
| Post subject: | |
I just changed my shock oils for the first time last weekend and the stock setup G clip with Mugen shock boots and after 6 races they were clean as a wistle and no leakage at all. I'd say the stock setup works very well, unless I got lucky. I used to run a Jammin CRT and the C clips worked well. Just wondering if the flat will cause less of a seal at all? The jammin C clips have a hole in the end of each side where it is open. I used to use a dentist tooth "pick" that has a little metal point to remove and replace or re-install the C clips. Then put a dab of CA glue on the clip to keep it in place. Worked great on the jammin shocks. I've been wating to find out if the new Jammin Big Bores would fit on the Xray. I'd love to see Xray come out with captured shock O rings in some new Big Bores like the jammin's. I hear they are the nicest on the market right now. |
|
| Author: | gtsum [ Thu Nov 08, 2007 03:30:44 ] |
| Post subject: | |
| Author: | MDJammin [ Thu Nov 08, 2007 19:37:50 ] |
| Post subject: | |
| Author: | MALLET [ Wed Jan 02, 2008 22:42:31 ] |
| Post subject: | |
| Author: | new but old [ Tue Jan 08, 2008 09:33:50 ] |
| Post subject: | I asked same ? about 3 months ago |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|