XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Drilled Shock Pistons https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=6231 |
Page 1 of 1 |
Author: | gtsum [ Mon Sep 17, 2007 03:33:16 ] |
Post subject: | Drilled Shock Pistons |
Does anyone know what the drill sizes are for drilling the pistons? I was gonna run 1.3's up front with two additional holes drilled in them and 1.4's in the back with two additional holes drilled. I assume you just drill the holes and space them as equally as possible? |
Author: | CarbonJoe [ Mon Sep 17, 2007 03:57:55 ] |
Post subject: | |
I suggest getting the GMK Supply "Hole Thing" drill set. It comes with a lot of metric drills in 1.05 to 2.00mm sizes (in 0.05 mm increments) and a finger drill holder. http://www.amainhobbies.com/product_inf ... ts_id/7599 I have used the 1.3 mm and 1.4 mm drills with it from the kit. A few turns with your fingers is all it takes. |
Author: | Richmond [ Mon Sep 17, 2007 04:05:25 ] |
Post subject: | |
Will that fit in a dremmel? |
Author: | CarbonJoe [ Mon Sep 17, 2007 04:26:24 ] |
Post subject: | |
Author: | gtsum [ Mon Sep 17, 2007 16:36:39 ] |
Post subject: | |
Thanks for the replies..that is what I needed! |
Author: | brano [ Tue Sep 18, 2007 14:34:47 ] |
Post subject: | |
The are already available for the new big bore shocks. |
Author: | gtsum [ Tue Sep 18, 2007 14:52:55 ] |
Post subject: | |
Author: | whitey4311 [ Tue Sep 18, 2007 16:00:20 ] |
Post subject: | |
Author: | Keith [ Tue Sep 18, 2007 16:32:51 ] |
Post subject: | |
Author: | gtsum [ Tue Sep 18, 2007 17:07:50 ] |
Post subject: | |
Author: | Keith [ Tue Sep 18, 2007 17:16:39 ] |
Post subject: | |
Author: | CarbonJoe [ Tue Sep 18, 2007 17:22:04 ] |
Post subject: | |
Author: | nsgland [ Sun Nov 11, 2007 01:51:33 ] |
Post subject: | TQ Shocks |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |