| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Fuel tank trigger/holders https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=6229 |
Page 1 of 1 |
| Author: | Richmond [ Sun Sep 16, 2007 22:02:52 ] |
| Post subject: | Fuel tank trigger/holders |
Can anyone tell me if those O_f__a fuel triggers/holders work with the XT8/XB8 fuel tanks? Is it long enough for the truggy? |
|
| Author: | CarbonJoe [ Sun Sep 16, 2007 22:19:15 ] |
| Post subject: | |
They should fit. But why spend $5 on something you can make from a few zip ties and fuel tubing? I use two narrow zip ties back to back (so the heads are facing opposite directions, and force them through so fuel tubing. It takes a while, but with a little wd-40, and some pliers, it can be done. Others use one, and make a loop before forcing the fuel tubing over. Personal choice, I guess. Easy to make custom lengths, too. |
|
| Author: | Keith [ Sun Sep 16, 2007 23:27:37 ] |
| Post subject: | |
Skip that idea Rich, I put one on my buggy tank and it was a pain in the buttocks. The loop on the tank end is not big enough. you can make it work, it just takes awhile. I had to heat it up and wrench it around and snake it thru there and dremel a bit here,,,Blahhhh!! 
Zipties and fuel tubing = waay less hassle and cheaper. 
|
|
| Author: | Richmond [ Mon Sep 17, 2007 03:42:27 ] |
| Post subject: | |
Point taken fellows...I did the zip tie fuel / tubing mod.
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|