| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Tool sizes for XB8 EC https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=5976 |
Page 1 of 1 |
| Author: | whitey4311 [ Fri Aug 10, 2007 03:26:16 ] |
| Post subject: | Tool sizes for XB8 EC |
| Author: | chris3g [ Fri Aug 10, 2007 03:37:05 ] |
| Post subject: | |
| Author: | whitey4311 [ Fri Aug 10, 2007 03:55:23 ] |
| Post subject: | |
| Author: | brano [ Fri Aug 10, 2007 06:47:11 ] |
| Post subject: | |
For the XB8 and XT8 cars you will need these tools: * or ; * or ; * or ; * or ; * or ; * or ; |
|
| Author: | whitey4311 [ Fri Aug 10, 2007 07:07:46 ] |
| Post subject: | |
Sweet thanks so much. |
|
| Author: | whitey4311 [ Fri Aug 10, 2007 16:11:35 ] |
| Post subject: | |
Can I ask how many places those socket drivers are used at? I have a cheapie cross wrench that if I only need it for a few spots I think I would save the money and go that route. However if there are a fair amount of places to use a socket driver I will go with the Hudy wrenches. |
|
| Author: | Rocco Margiotta [ Fri Aug 10, 2007 16:14:25 ] |
| Post subject: | |
You can also dremel the inside of the 8mm Nut Driver (17 0080) for clearence so you can use it on the shock tower nuts (35 8045). 15 4060 - Tuning screw driver... Don't forget the new wheel wrench and flywheel tool as well!!!! 10 7570 - 17mm Wheel Wrench (which should be in shortly) 18 2010 - Flywheel tool |
|
| Author: | whitey4311 [ Sun Aug 12, 2007 06:06:28 ] |
| Post subject: | |
| Author: | Keith [ Sun Aug 12, 2007 14:35:06 ] |
| Post subject: | |
| Author: | whitey4311 [ Sun Aug 12, 2007 15:39:19 ] |
| Post subject: | |
| Author: | Rocco Margiotta [ Tue Aug 14, 2007 18:23:10 ] |
| Post subject: | |
We did just get the HUDY 17mm wheel wrench in stock...... 107570 |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|