XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Motor won't shim up correctly https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=5698 |
Page 1 of 1 |
Author: | sjurick [ Sun Jun 17, 2007 03:56:03 ] |
Post subject: | Motor won't shim up correctly |
Author: | vdubbintdi [ Sun Jun 17, 2007 05:29:15 ] |
Post subject: | |
Author: | sneh [ Mon Jun 18, 2007 02:55:58 ] |
Post subject: | |
Author: | sjurick [ Mon Jun 18, 2007 15:00:58 ] |
Post subject: | |
Author: | Keith [ Mon Jun 18, 2007 15:37:48 ] |
Post subject: | |
Author: | sjurick [ Mon Jun 18, 2007 16:39:52 ] |
Post subject: | |
Author: | Keith [ Mon Jun 18, 2007 17:20:16 ] |
Post subject: | |
Author: | sjurick [ Mon Jun 18, 2007 18:33:11 ] |
Post subject: | |
Author: | Keith [ Mon Jun 18, 2007 19:17:03 ] |
Post subject: | |
Author: | Leon McIntosh [ Mon Jun 18, 2007 21:43:19 ] |
Post subject: | |
sjurick- and others keep in mind when you put the flywheel and clutch nut on you should have between 10 and 11 mm of shaft left. if your looking to use the large washer that comes with the kit i would recomend spacing the flywheel so that you have closer to 10mm of shaft left from top of clutch nut to end of shaft and that should give you the perfect amount of play |
Author: | sjurick [ Mon Jun 18, 2007 23:20:08 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |