XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Rear up links shaped so as to not touch the wheels https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=5661 |
Page 1 of 1 |
Author: | Z [ Tue Jun 12, 2007 16:02:23 ] |
Post subject: | Rear up links shaped so as to not touch the wheels |
Talking about the EC: This should not be an option but... I would suggest rear up links shaped so as not to touch the inside of the wheel when setting the rear roll center using the upper holes on the side of the shock mounting plate. I would also suggest a rubber seal so to really close the receiver/batt box and better protect our equipment against sand and liquids. Lastly, I would suggest to partition the receiver box so as to separate the battery side from the receiver side, avoiding thus to get sand entering the receiver side when opening the box so to charge or remove or exchange the batteries. What else ? this car has everything (!) |
Author: | Z [ Tue Jun 12, 2007 16:28:27 ] |
Post subject: | I apologize |
I meant to post this message in the suggestions.. but did a mistake... my apologies to the webmaster. Z ![]() |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |