XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
chassis question https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=5643 |
Page 1 of 1 |
Author: | sllo [ Sat Jun 09, 2007 16:18:19 ] |
Post subject: | chassis question |
Author: | carlo71 [ Sat Jun 09, 2007 16:38:56 ] |
Post subject: | |
Author: | Rocco Margiotta [ Sun Jun 10, 2007 15:51:10 ] |
Post subject: | |
Author: | sllo [ Sun Jun 10, 2007 16:24:21 ] |
Post subject: | |
I have everything bolted in still it is not flat. After closer look when I put the ruler paraller against the bottom of the chassis the back lifts up near the first screw of the rear brace. And as I wrote before there is a 4mm gap between the rear end, where the rear bumber is and the ruler. |
Author: | Keith [ Sun Jun 10, 2007 16:33:57 ] |
Post subject: | |
Uh oh! tweaked chassis. One of the team drivers bent a new EC or XT8 (cant remember) but they weren't running a rear brace if I recall. Silo, you were using the plastic rear brace or the alum? |
Author: | sllo [ Sun Jun 10, 2007 16:44:27 ] |
Post subject: | |
Author: | Keith [ Sun Jun 10, 2007 16:50:52 ] |
Post subject: | |
Author: | sllo [ Sun Jun 10, 2007 17:39:48 ] |
Post subject: | |
Author: | Keith [ Sun Jun 10, 2007 18:02:09 ] |
Post subject: | |
Author: | dbarnes [ Mon Jun 11, 2007 14:41:28 ] |
Post subject: | |
Author: | Craige Lewis [ Mon Jun 11, 2007 14:50:49 ] |
Post subject: | |
Author: | Keith [ Mon Jun 11, 2007 16:27:03 ] |
Post subject: | |
Author: | Rocco Margiotta [ Mon Jun 11, 2007 19:30:15 ] |
Post subject: | |
Author: | sllo [ Thu Jun 14, 2007 20:11:29 ] |
Post subject: | |
Author: | sllo [ Fri Jun 15, 2007 06:29:08 ] |
Post subject: | |
Author: | Jason Branham [ Fri Jun 15, 2007 14:14:17 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |