XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
XB8 EC Driveshaftpins https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=5582 |
Page 1 of 1 |
Author: | bmx [ Thu May 31, 2007 21:09:06 ] |
Post subject: | XB8 EC Driveshaftpins |
I was about to clean and rebuilt my buggy for this weekends swiss-champ race. i had to replace the centershaftpins with the original hudy tool for this, but they hold to strong in the shaft, only moved a little. cant get them out. [hit the pin-tool with the hammer that much, that the tool (pin of toolpart C) destroyed ![]() ![]() are they manufactured different then the ones of the XB8? because i never had any problems before doing this at my XB8's shafts. regards, mike sorry for my bad english ![]() |
Author: | Barkley Abernethy [ Thu May 31, 2007 22:56:40 ] |
Post subject: | |
Author: | bmx [ Fri Jun 01, 2007 00:39:19 ] |
Post subject: | |
Author: | Barkley Abernethy [ Fri Jun 01, 2007 17:24:41 ] |
Post subject: | |
when i say heat i mean gas flame till the shaft just turns lightly red .if you have never used this method before i suggest you be carefull or get someone to do it for you.......its known in ireland as the red spanner treatment ![]() |
Author: | Keith [ Fri Jun 01, 2007 21:58:36 ] |
Post subject: | |
Author: | bmx [ Fri Jun 01, 2007 23:00:42 ] |
Post subject: | |
Author: | Barkley Abernethy [ Sat Jun 02, 2007 08:35:36 ] |
Post subject: | |
Author: | Keith [ Sat Jun 02, 2007 16:03:51 ] |
Post subject: | |
If all else fails,,try the flame wrench. lol! |
Author: | mario [ Sun Jun 03, 2007 14:50:28 ] |
Post subject: | |
Author: | low10s [ Sun Jun 03, 2007 16:47:06 ] |
Post subject: | |
Author: | Keith [ Sun Jun 03, 2007 16:55:45 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |