XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Alu Rear Hub Carrier stock equivalent settings https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=5447 |
Page 1 of 1 |
Author: | CarbonJoe [ Wed May 09, 2007 06:22:40 ] |
Post subject: | Alu Rear Hub Carrier stock equivalent settings |
Author: | Jason Branham [ Wed May 09, 2007 14:25:07 ] |
Post subject: | |
CarbonJoe, It would be the 0 bushings in both sides of the alum. upright. Jason Branham |
Author: | CarbonJoe [ Wed May 09, 2007 17:25:14 ] |
Post subject: | Thanks! |
Author: | Jason Branham [ Wed May 09, 2007 20:07:22 ] |
Post subject: | |
I run all my toe from the hinge pins and keep the rear uprights strait. You will see this from most of the team drivers. Jason Branham |
Author: | GregM [ Wed May 09, 2007 20:45:49 ] |
Post subject: | |
Whats the difference in handling between the two options, i.e hinge pin verse hub? |
Author: | Rocco Margiotta [ Wed May 09, 2007 22:59:17 ] |
Post subject: | |
I think the onboard toe has a more prominent effect than outboard. Also the inboard toe will have more of an effect on wheelbase too... |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |