XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Xray XT8 Offsett Wheels? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=5427 |
Page 1 of 1 |
Author: | Brian M [ Mon May 07, 2007 19:50:13 ] |
Post subject: | Xray XT8 Offsett Wheels? |
Author: | Jason Branham [ Mon May 07, 2007 20:23:28 ] |
Post subject: | |
Brian, The XT8 rims are the same as the Jammin wheels (1/2 off set). As far as the hub extenders I could not tell you what ones to get but even though the standard rims from Pro-line are 0 off-set it still appears that they have about a 1/4 off-set, so I would guess any hub adapter with 1/4 extension would match the XT8 wheel. Hope this helps. Jason Branham |
Author: | Brian M [ Mon May 07, 2007 21:21:18 ] |
Post subject: | |
It does. Thanks JB |
Author: | Rocco Margiotta [ Mon May 07, 2007 22:02:46 ] |
Post subject: | |
Heads up! The Jammin wheels are a little deeper than the XT8's wheels. The XT8 runs a 10 mm offset, if you wanted to match it with wider hubs, you will need to put a 6mm wider hub on the truck to get back to stock width with the proline standard offset wheels. This for sure as I just measured them with calipers, you need a 6mm hub to get back to stock width when using proline wheels, which is very close to 1/4 inch. |
Author: | Chris Crews [ Tue May 08, 2007 03:36:37 ] |
Post subject: | |
Rocco is correct. I tested out some 6mm extenders for a K truck from king headz and all i had to do was drill the hole out for the axle pin and they were a direct fit. As a result i was able to put K style rims on with no problem what so ever. Xray has made their own offset exclusive to them. More offset than the K style and not as much as Jammin. |
Author: | Brian M [ Tue May 08, 2007 16:20:02 ] |
Post subject: | |
Author: | Rocco Margiotta [ Tue May 08, 2007 18:00:20 ] |
Post subject: | |
It's molded into them. |
Author: | carlo71 [ Wed May 09, 2007 01:41:32 ] |
Post subject: | |
Author: | Rocco Margiotta [ Wed May 09, 2007 03:24:33 ] |
Post subject: | |
Author: | Brian M [ Wed May 09, 2007 17:25:11 ] |
Post subject: | |
Author: | Keith [ Wed May 09, 2007 17:58:49 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |