XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Standart enginge mount only fits with a 15 Tooth clutch o https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=5037 |
Page 1 of 1 |
Author: | stephanFlint [ Sun Feb 18, 2007 19:28:57 ] |
Post subject: | Standart enginge mount only fits with a 15 Tooth clutch o |
Hello, greets from Germany i have a problem with my engine mount. I have the standart 2 piece mount and a RB Ws7 2 engine. The only way to get it into the car is to use a 15t Cluth. I want to use an 13t bell but the broblem is, that the engine mount would touch my drive shaft. (Middle to rear) What should i do? does it fit with this big one piece mount ? 358712 With main Wheel should i unse 46t smaller? with is stock size? hope you understand my problem, thanks, Stephan |
Author: | sllo [ Sun Feb 18, 2007 22:08:34 ] |
Post subject: | |
I have the ws7II installed with a mugen 13 CB and it fits perfectly. There is a very small gap between the back of the engine mount and the drivershaft, but they dont touch each other. Maybe you didnt align the engine paraller to the spur gear and part of the engine mount is touching the driveshaft. |
Author: | stephanFlint [ Sun Feb 18, 2007 22:49:54 ] |
Post subject: | |
you are right...i was about to clean the car and so i built out the engine, and it has been not paralell to the shaft....allright, it works rightnow. thank you |
Author: | sneh [ Mon Feb 19, 2007 00:18:20 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |