XRAY - Model racing cars

Hello, greets from Germany

i have a problem with my engine mount.
I have the standart 2 piece mount and a RB Ws7 2 engine. The only way to get it into the car is to use a 15t Cluth. I want to use an 13t bell but the broblem is, that the engine mount would touch my drive shaft. (Middle to rear)

What should i do? does it fit with this big one piece mount ? 358712
With main Wheel should i unse 46t smaller? with is stock size?

hope you understand my problem, thanks, Stephan

I have the ws7II installed with a mugen 13 CB and it fits perfectly. There is a very small gap between the back of the engine mount and the drivershaft, but they dont touch each other.
Maybe you didnt align the engine paraller to the spur gear and part of the engine mount is touching the driveshaft.

you are right...i was about to clean the car and so i built out the engine, and it has been not paralell to the shaft....allright, it works rightnow.
thank you