| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| break in bench help? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=4941 |
Page 1 of 1 |
| Author: | low10s [ Thu Feb 01, 2007 02:41:31 ] |
| Post subject: | break in bench help? |
i got this thing mounted it up and the engine will not start for nothing. dont know if it is not fast enough or what but i have a Snap on air drill going to it...it is fast but i am at a loss. thanks |
|
| Author: | Rich Panganiban [ Thu Feb 01, 2007 05:07:51 ] |
| Post subject: | |
Make sure your air drill is spinning the engine in the correct direction. If that doesn't work, install an already broken-in engine and see if it fires up. |
|
| Author: | low10s [ Thu Feb 01, 2007 06:18:31 ] |
| Post subject: | |
it is a brand new 21-7bt...when i ran it in the buggy the carb gave me problems..so i put an rb carb on there and it was fine. so i checked the stock carb out, it looked okay so i put it on to try it again...and no dice. but what you suggested was already in the plans..thanks for the input. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|