XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Plastic Steering Servo Arm? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=463 |
Page 1 of 1 |
Author: | CASEY [ Tue Nov 16, 2004 00:38:25 ] |
Post subject: | Plastic Steering Servo Arm? |
Author: | Rich Panganiban [ Tue Nov 16, 2004 00:40:51 ] |
Post subject: | |
Author: | Booyah [ Tue Nov 16, 2004 04:39:10 ] |
Post subject: | |
I was going to use an aluminum one, but after I saw the beefy plastic one supplied I went with it! I wont be able to run till summer either ![]() |
Author: | nitrojim [ Tue Nov 16, 2004 05:02:36 ] |
Post subject: | |
I too have always run aluminum ones also but the ones the xb8 comes with is stout and have not had any problems with flexing. |
Author: | z-man [ Tue Nov 16, 2004 05:11:11 ] |
Post subject: | |
i think it being layed down helps too. i am using the plastic for the first time and kinda like it. |
Author: | imaxx21 [ Tue Nov 16, 2004 06:22:45 ] |
Post subject: | |
o yeah the xray one rocks!!! |
Author: | SupermaxxRich [ Tue Nov 16, 2004 09:36:54 ] |
Post subject: | |
I'm running the Xray plastic one and so far its a stout piece!!! I have the servo saver spring cranked pretty tight!!! ![]() ![]() ![]() |
Author: | showtime [ Tue Nov 16, 2004 09:46:36 ] |
Post subject: | |
the supplied plastic arms look ok to me ![]() i have pretty much only used alloy before but they seem stiff enough & are the right length etc, i thought the whole linkage, steering/throttle/brake etc built up really easy from the kit parts ![]() some cars are a right pain to get them set right first time! |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |