| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| swaybar in TQ https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=4569 |
Page 1 of 1 |
| Author: | taehun kim [ Wed Nov 29, 2006 03:56:37 ] |
| Post subject: | swaybar in TQ |
| Author: | acmarta [ Wed Nov 29, 2006 06:40:24 ] |
| Post subject: | |
Hi taehun, I believe this question has already been answered here: viewtopic.php?t=4485 Basically, you need to unscrew a few threads on the swaybar linkage to make it longer so that the swaybar sits higher, allowing more down travel without touching the diff outdrives. Hope this helps, Andre |
|
| Author: | taehun kim [ Wed Nov 29, 2006 06:50:57 ] |
| Post subject: | acmarta |
| Author: | acmarta [ Wed Nov 29, 2006 06:59:16 ] |
| Post subject: | |
| Author: | taehun kim [ Wed Nov 29, 2006 07:05:31 ] |
| Post subject: | got it |
| Author: | taehun kim [ Wed Nov 29, 2006 18:53:23 ] |
| Post subject: | |
here is my pics. for problem i try to unscrew to the link but not enough screw length to extend the link i think that need more longer screw my setting is below front lower arm: f: up 1 r: down 1 front upper arm f: up 1 r: down 1 droop down screw : full [img]http://pds8.cafe.daum.net/download.php?grpid=tn7x&fldid=2uWz&dataid=44&fileid=1®dt=20061130014756&disk=7&grpcode=view002&dncnt=N&.JPG http://pds9.cafe.daum.net/download.php? ... cnt=N&.JPG http://pds12.cafe.daum.net/download.php ... cnt=N&.JPG http://pds13.cafe.daum.net/download.php ... cnt=N&.JPG http://pds14.cafe.daum.net/download.php ... cnt=N&.JPG http://pds15.cafe.daum.net/download.php ... cnt=N&.JPG http://pds16.cafe.daum.net/download.php ... cnt=N&.JPG[/img] |
|
| Author: | Rocco Margiotta [ Wed Nov 29, 2006 19:36:23 ] |
| Post subject: | |
You can also bend it ever so slightly to keep it off the outdrive, I have done this in the past... |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|
