XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Wheel base at rear hinge pins https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=4515 |
Page 1 of 1 |
Author: | sgarvin [ Fri Nov 17, 2006 14:51:37 ] |
Post subject: | Wheel base at rear hinge pins |
Author: | Jason Branham [ Fri Nov 17, 2006 15:53:02 ] |
Post subject: | |
It will be ok with the 2mm, that is what I use and yes there is a little play but it's not going to hurt anything. I have see people take the 3mm and take a little off with some sand paper to make the fit a little tighter if you want to try that. |
Author: | sgarvin [ Fri Nov 17, 2006 17:44:17 ] |
Post subject: | |
Author: | dbarnes [ Fri Nov 17, 2006 19:54:51 ] |
Post subject: | |
I think this topic has been brought up before. Mine fit perfectly with the 3mm spacer too so I would use that if I were you. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |