XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Setting Center Spur Gear https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=4361 |
Page 1 of 1 |
Author: | JerKap [ Sun Oct 15, 2006 20:29:27 ] |
Post subject: | Setting Center Spur Gear |
Anyone come up with a good process for setting the mesh on the center spur gear and clutch bell.? Some guys ,, put a paper between the gears... but this doesn't work on the XRay,,, the Xay needs a looser mesh... Maybe using thicker paper ,,, but how thick is my question... I learned this the hard way... I got may XB8 when it first came out and had not problem with this,,, till I made the mesh a little tighter,, ,, bad move,, should have left it alone.... spur gone, clutch bell gone... Thanks |
Author: | Rosco [ Mon Oct 16, 2006 05:33:45 ] |
Post subject: | |
Author: | Asterix [ Mon Oct 16, 2006 12:15:30 ] |
Post subject: | |
i use a standard 80gms paper and it works fine. |
Author: | Keith [ Thu Oct 19, 2006 21:31:51 ] |
Post subject: | |
I eyeball it with the fuel tank off (you can look right at the contact areas) making sure there is about 1/2 to 3/4 of tooth contact between bell and spur. |
Author: | Asterix [ Thu Oct 19, 2006 21:55:52 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |