| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Alloy front knuckle mounting https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=4182 |
Page 1 of 1 |
| Author: | sneh [ Sun Sep 03, 2006 05:36:58 ] |
| Post subject: | Alloy front knuckle mounting |
| Author: | WalawalaStore [ Sun Sep 03, 2006 12:01:50 ] |
| Post subject: | |
| Author: | sneh [ Sun Sep 03, 2006 14:49:08 ] |
| Post subject: | |
they only line up in the carrier the one way dont they? did you use the same ball stud and nyloc nut setup? |
|
| Author: | WalawalaStore [ Sun Sep 03, 2006 17:32:06 ] |
| Post subject: | |
hi, I use everything including screws and nuts supplied by the kit, check this pic, the proper side should be facing upwards and the machined side facing down: Also the aluminum knuckles have "L" and "R" marked on them. Please check. Thx Joaquim |
|
| Author: | Richmond [ Sun Sep 03, 2006 17:36:18 ] |
| Post subject: | |
I dremeled the arm slightly to allow for the steering throw. You can check the tips and tricks section. There's an arm mod/ steering throw topic by David Joor which shows in detail how it's done. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|