XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Reasons to change to rear al. hub carriers . . https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=3962 |
Page 1 of 1 |
Author: | Richmond [ Fri Jul 28, 2006 19:15:10 ] |
Post subject: | Reasons to change to rear al. hub carriers . . |
Author: | ajoiner490 [ Sat Jul 29, 2006 00:15:54 ] |
Post subject: | |
You can put up to 2* of toe AT the hub, allowing the arm to be at a lesser angle and reduce stress. When I run the alum. rear hubs, I usually put 1* at the rear block and 2* at the hubs for a total of 3*. The plastic hubs are a little more forgiving on a rough track than the aluminum rears as well. |
Author: | Richmond [ Sat Jul 29, 2006 00:24:23 ] |
Post subject: | |
Thanks for the info Adam. I'm using the soft arms and I'm concerned of the arms wearing out like how others reported them of doing. Also, wassup with the rear outer pin problem? Has that already been fixed? |
Author: | Dan Reynolds [ Sat Jul 29, 2006 07:58:20 ] |
Post subject: | |
I've been using the alu rear hub with the soft arms for the last 6 months and I haven't experianced any wear problems |
Author: | Keith [ Sat Jul 29, 2006 11:05:16 ] |
Post subject: | |
Author: | ajoiner490 [ Sat Jul 29, 2006 16:52:40 ] |
Post subject: | |
Author: | Richmond [ Sat Jul 29, 2006 18:19:28 ] |
Post subject: | |
Author: | Keith [ Sat Jul 29, 2006 19:03:58 ] |
Post subject: | |
Author: | nitroracer [ Sat Jul 29, 2006 19:19:50 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |