XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Clutch bearings question https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=3720 |
Page 1 of 1 |
Author: | Harri [ Sat Jun 03, 2006 21:23:43 ] |
Post subject: | Clutch bearings question |
Author: | harder [ Sat Jun 03, 2006 21:46:50 ] |
Post subject: | |
Author: | ChrisP [ Sat Jun 03, 2006 21:57:02 ] |
Post subject: | |
Author: | mario [ Sun Jun 04, 2006 14:57:00 ] |
Post subject: | |
The feedback has been up to now that the new steel covered bearings specially made for the clutch are excellent and have some of the highest life-time. If you have to change bearings after each tank than something wrong is going on. |
Author: | nitroracer [ Sun Jun 04, 2006 17:20:00 ] |
Post subject: | |
Most likely your idle is set to high. That will kill the bearings very quickly because the clutch area overheats. Also make sure you are not using static brake to keep a high idle from making the car roll at neutral. |
Author: | ctr_mint [ Sun Jun 04, 2006 23:13:46 ] |
Post subject: | |
Author: | Brixen [ Mon Jun 05, 2006 10:23:42 ] |
Post subject: | |
Author: | Andy Taylor [ Mon Jun 05, 2006 18:14:15 ] |
Post subject: | Re: Clutch bearings question |
Author: | Joao Pina [ Tue Jun 06, 2006 02:15:32 ] |
Post subject: | |
check if the 2 bearings do not enter in the cluch bell with exagerated play |
Author: | Harri [ Tue Jun 06, 2006 08:56:25 ] |
Post subject: | |
Author: | Brixen [ Tue Jun 06, 2006 11:29:07 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |