I have just bought the alu rear hubs and I’m using the 2’ outboard toe set of eccentric bushings. I used the 0-2’ rear holder with the 0 eccentric bushing (which gives 1’ of inboard toe) which should give me 3’ toe altogether.
I was checking the camber on the rear with my Hudy set up system, and I never bother measuring rear toe because it should be whatever I set it to using the eccentric bushings, but I thought as I was there I would check it, but it came out to 4’
so I used the number 1 eccentric bushing to give me 0 rear to on the rear holder and low and behold I had 3’.
The only place I have any rear toe at all is on the rear hub, but I have 3’ and not the expected 2’
Has anyone else noticed this? As I can’t think where the extra 1’ has come from
