Joined: Sun Oct 23, 2005 22:18:14 Posts: 12
|
How far should the flywheel fit on the collet to be acceptable? I just rebuilt my RB S5 and put a new flywheel and clutch (all stock xray parts) and with the three washers, the collet and then the flywheel tightened I fall within the 11.0 - 11.2 spec. I take it the flywheel doesn't need the collet completely in it to be proper. Is this correct? Just want to make sure as I didn't check when I took off the mugen clutch setup that was on the engine previously. Thanks.
|
|